What is the problem of high fuel consumption of anticorrosive fan

What is the problem of high fuel consumption of anticorrosive fan

1 The air filter is clogged and the anticorrosive fan is in vacuum operation, which increases the oil consumption of the fan. All you need to do at this point is to clean the sponge of the air filter.

2 The deterioration of lubricating oil or the rust of fan inlet water can also cause the fan to consume oil quickly. The lubricating oil deterioration only needs to change the lubricating oil, and the fan entering aquatic rust needs to be repaired by dismantling machine.

3 The deterioration of lubricating oil or the rust of fan inlet water can also cause the fan to consume oil quickly. The lubricating oil deterioration only needs to change the lubricating oil, and the fan entering aquatic rust needs to be repaired by dismantling machine.

4 It may be caused by blockage of pipe or aeration head, disassemble fan outlet, clean up pipe spoils and replace aeration head.

5 There is dirt or lack of lubricating oil inside the fan. Clean it up or add lube oil.

6 If a collision occurs in the course of transportation or loading and unloading, causing the fan rotor to lean off, we can release the rear end cover screw, gently tap the end cover with a wooden hammer, and gently pull the belt with the hand until it feels that the fan is not jammed. Tighten the back cover screw. If the fan or motor bearing is broken, replace the bearing.

7 The small air volume anticorrosion fan is used in the place where large air volume is needed, which leads to the overload operation of the fan and causes the fan to consume oil too quickly. The suitable air volume fan should be selected in different places.

In general, a lot of factors may lead to the same problem, so when we solve the problem of anticorrosive fan, we must carefully analyze the cause of the problem, so that we can continue to use it better.www.jnblower.com